Drylin D1 motor control system for stepper, DC and EC/BLDC motors

  

A wide range of automation tasks by simple parameterisation, no programming necessary. For single axes, line, flat, linear and room linear robots and delta robots. No software installation or app required.

Stepper (ST), DC and EC/BLDC motors with up. To 21A peak currents and 48V.

Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff. Travel distances, positions, speeds, operating times - easily defined with the new igus® web-based control system for drylin® E linear systems. No software or app installation necessary, fast commissioning. Simple and intuitive user interface, control system set up in just a few minutes. Compatible with numerous industrial controllers e. For DC, EC and stepper motors. The dryve motor control system can either be connected to your network or you can connect it directly to the control unit (PC or PLC) by means of a network cable. Settings can therefore be made in one minute. You can use the simple intuitive user interface to parameterise travels, position, speed and operating time of your linear axis even as an amateur. Movements that are continuously repeated are known as "looping" and can be set in just a few seconds. Due to standardised communication protocols such as CANopen or Modbus TCP as gateway, it is very easy to connect the system to industrial controllers, such as the Siemens S7 or Beckhoff. The ten digital inputs and five outputs enable extremely easy communication with industrial controllers but also with low-price open-source modules, such as Arduino or Raspberry Pi. Dryve supports DC, EC and stepper motors both in open loop and closed loop technology. The supply voltage of up to 48V ensures high motor speeds. The nominal current of 7A and the peak current of 21A results in powerful and dynamic movements.