Made of high quality plastic and stainless steel material, durable and wear resistant. When using a sauna heater, you need to sprinkle water to have steam. With this automatic spray device, it will automatically spray water without pouring water and save time. Easy to install and operate, excellent workmanship and stable performance.Condition: 100% Brand New Item Type: Spa Control Switch Material: Plastic + Stainless Steel Color: As shown in the picture Size: Approx. 27x14.5x3cm / 10.6x5.7x1.2in Weight: Approx. 951g/33.5oz Application: Suitable for sauna room, bath place, spa tank, hot spring pool, spa pool, steam room Induction Head Voltage: DC12V Battery Valve Voltage: AC12V Spray Device: Power supply voltage AC220V, output: 12v Inlet Valve: AC-12V Inlet Valve Diameter: Male thread 21mm/0.8in Please note when installing: 1. When installing the solenoid valve, please note that the direction on the valve body is the same as the water direction. It must be connected to the water pipe with a hose to minimize the pressure. A valve must be added in front of the solenoid valve for water volume adjustment and maintenance. The connecting pipe between the solenoid valve and the sauna heater should retain a trap to prevent the solenoid valve from being burned out by the sauna heater. For multiple panel switches, please connect them in parallel between V+ and SW (between 6# and 5#), generally no more than 5 at most. For the water spray device equipped with sensors, when installing an induction head, the wiring should be between V+ and K1 (between 6# and 4#); if two induction heads are installed, the two induction heads should be the same when wiring Color lines are connected in parallel. If there are more sensor heads, it can be connected between V+ and K2 (between 6# and 3#).
Whether it is a sensor head or a switch, all the red wires are connected to V+ (6#). The sensor should be installed in a location with relatively low temperature to avoid the influence of high temperature on internal components and cause the sensor to fail. Time adjustment: the longest water spray time is 3 seconds, and the time can be reduced by flipping the switch upward, and it will be reduced by 0.5 seconds for each switch (generally do not adjust at will).
Troubleshooting: The solenoid valve keeps water out: Please check whether the solenoid valve inlet and outlet pipes are installed in the direction of the. If the inspection is correct, please check whether there is any foreign matter inside the solenoid valve. The solenoid valve does not out: After powering on, look at the right indicator on the controller. If it is always on, it may be that the panel switch is not installed or not working, or the wiring is wrong, just connect according to the diagram.
1 x Stainless Steel Tube. Please allow 1-2cm error due to manual measurement. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.Instead of leaving negative/neutral feedback or opening a dispute. Our listing price includes the value of goods, packaging cost, and export.
Please check with your country's. We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls.
Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls. Our aim is to provide Level Customer Service, your recognition will encourage us greatly and serve you better. We strive to keep all our customers satisfy.
We will do our up most to exceed your expectations in customer service, communication and dispatching of your orders. This item is in the category "Video Games & Consoles\Video Game Accessories\Controllers & Attachments".
The seller is "goodfeeling360" and is located in this country: CN. This item can be shipped worldwide.